publiber.blogg.se

1. #HOW TO DISPLAY A WANTED NUMBER IN PASCO CAPSTONE SOFTWARE#
2. #HOW TO DISPLAY A WANTED NUMBER IN PASCO CAPSTONE CODE#

You can mount the sensor vertically with the pulley facingįorward. It is possible to mount the Rotary Motion Sensor horizontally on a support rod with the Three-step Pulley facing up or facing sideways. Move the rod clamp to one of the additional mounting positions on either side of the case and use the hex key to tighten the screws in place. The two screws do not need to come out all the way they are held inside the rod clamp by small O-rings. Use the included hex key to loosen the two screws that hold the rod clamp on the Rotary Motion Sensor case. Sparkview is very easy to use and the online library for training and pracs is amazing through Pasco, as a lab tech you could spend weeks there Highly recommend. Awesome, once off purchase 400 then lifelong updates free. it's Sparkview on steroids for our Yr 11 and 12 classes.

#HOW TO DISPLAY A WANTED NUMBER IN PASCO CAPSTONE SOFTWARE#

Site to the cable and on either side of the case. We also use the Capstone software (Pasco). ME-8736 45 cm Stainless Steel Rod, and the rod clamp can beĪttached to the sensor in three different locations: at the end oppo. The rod clamp fits rods up to 12.7 mm in diameter, such as the Model No.PS-2120A Introduction Mounting the Rotary Motion Sensor

#HOW TO DISPLAY A WANTED NUMBER IN PASCO CAPSTONE CODE#

The gear teeth on the rack mesh with the gear teeth on the optical code wheel inside the sensor. The T-slot through the sensor is for inserting the optional Linear Motion Accessory rack (CI-6888). The end of the sensor where the cord exits the case has a platform for mounting a Super Pulley with Table Clamp (not included). The hex key fits in the storage hole near one end of the sensor and is held in place by a rubber “O”-ring inside the sensor. The included hex key (allen wrench) allows the rod clamp to be removed from the end of the sensor and mounted on either the right-hand or left-hand side. The pulley has a notch and a small hole in the outer edge of the largest and second largest steps for attaching a string. A tab on the inside of the pulley matches a notch on the outside of the shaft. Three-step pulley can be attached to either end of the shaft, and can be placed large-diameter down or large-diam- eter up on the shaft. The sensor comes with a removable three-step pulley (10 millimeter (mm), 29 mm, and 48 mm diameters), and a rubber “O”-ring that fits into the largest diameter step. The optical code wheel inside the sensor has 4000 divisions per revolution (360°), Direction indicator and the maximum speed is 30 revolutions per second. Markings on the outside of the case indicate which is the default positive direc.

It measures angles to a resolution of 0.09°, and detects the direction of The PASCO PS-2120A Rotary Motion Sensor is a versatile position and motion measuring device.